|
ACRYLIC-TIE ADHESIVE
Acrylic-Tie is a two component, 10:1 ratio acrylic based adhesive for use as a
high strength, anchor grouting material. Formulated for use in all types of
weather, AT is designed to dispense easily and cure at temperatures down to
0°F. Resin and initiator are dispensed and mixed simultaneously through the
mixing nozzle. AT meets the physical requirements of ASTM C881, Type I &
IV, Grade 3, Classes A, B & C, except Acrylic-Tie is a non-epoxy product
formulated for fast cure time.
APPLICATIONS:
-
Threaded rod anchoring
-
Rebar dowelling
-
Paste-over for crack injection
-
Pick proof sealant around doors, windows and fixtures
FEATURES:
-
Ideal for cold weather anchoring: cures in temperatures down to 0°F
-
Constant viscosity: dispenses easily at the coldest temperatures without need
to warm the cartridge Fast cure at temperatures above 60°F
-
Non-sag formulation: Ideal for vertical and most overhead applications
-
Excellent cold load value: No reduction in load capacity for cold weather
applications
-
Versatile: for use in concrete, brick and concrete block. Suitable for use in
damp, wet and water-filled holes.
-
Mixing nozzle included with 5,8 and 13 oz. cartridges.
ADT30
|
Manual Dispensing Tool for 30oz. Cartridges –
The ADT30 features a steel carriage and a molded
nylon reinforced body for ultimate strength and light
weight. The handle is positioned under the cartridge for
balance and ease of use. The drive mechanism is released
by pushing forward on the drive handle.
|
ADT30P
|
Pneumatic Dispensing Tool for 30oz. Cartridges –
The ADT30P has an ergonomically designed nylon
reinforced handle complete with:
-
Air supply attachment is 1/4-18 NPT (male) thread.
-
Recommended operating air pressure is
between 80-100 psi (116 psi max.).
|
Mixing Nozzle
EMN22
|
EMN22 (Depending on packaging) –
An 18 element mixing nozzle for use with 22oz.
and 56oz. Epoxy-Tie cartridges and the 30oz.
Acrylic-Tie cartridge. This nozzle requires a separate
nozzle retaining nut to attach to the cartridge
.
|
|
